Angular Contact Ball Bearing,Angular Contact Ball Bearing 3203,Angular Contact Ball Bearing 71900 Hewitt Bearing Transmission Technology Co., Ltd. , http://www.wx-bearing.com
Electronic pull machine random accessories how to install? There are two sets of packaging boxes for the electronic tension machine. The contents of the packaging box are not only different, but also have different installation methods. The following Haida Xiaobian introduces you to the installation of the following accessories. The installation of the host in the main box is not described here in detail.
1. Install the power supply plug: Plug the power plug and the computer's power plug into the power outlet.
2, the installation of electrical lines:
1) Input control signal to interface 2 via cable
2) The load sensor signal output interface 1 is connected to the corresponding interface of the host computer.
3) Install one end of the power cord to the power cord plug 4 and fasten the nut, and install the other end to the power transformer.
3, the printer's installation: open the box, according to the installation instructions, placed on the right side of the computer desktop.
4. Installation of computer host and monitor: Open the boxes for both, and follow the instructions. Place the monitor in the middle of the computer's desktop, and place the main unit in the main box at the bottom right.
5, the installation of the computer desk: The packaged computer desk will be removed, according to the installation instructions will be installed on the right side of the test machine host.
The above is the installation method of some accessories of electronic tension machine. The following Haida Xiaobian will introduce the maintenance of the control system:
1. The interface on the plug-in controller must be turned off;
2. The controller interfaces need to be in one-to-one correspondence, and they cannot be inserted wrong, otherwise they will cause damage to the machine.
3. If the controller does not use it for a long time after the test, close the controller and the computer;
4. Regularly check the connection line of the rear panel of the controller for good contact, loosening and timely tightening.
Electronic pull machine random accessories how to install? Through the above introduction we all know that it is installed, of course, now the general factory delivery will be installed to the user in the past, but users still use the transfer of the place.
Article Source: Dongguan Haida International Instrument is not allowed to reprint without permission! (Or: if you need to reprint, indicate the source)
Electronic pull machine random accessories how to install?
Electronic pull machine random accessories how to install?